Double Facer (Binding&Drying Part) For Corrugated Paper Production Line

*Corrugated paper enter into the double facer hot parts with heating and molding after pasted glue, and  become board after cooling

*Hot Plates' surfaces is ground and then chromed plated,width 600mm and 14 pics,cooling parts 4m

*Hot plates adopts the compressed press rollers structure,it lifting adopt pneumatic structure

*Heat conductive pipe of hot plates control the temperature segmented

*The inside of the hot plate is partition isolation structure,making the steam flow in S-shaped direction, and the separation function of steam and water is obvious,then improves the steam usage efficiency

*Up convey belt left and right correct by auto with both sides,Under belt adopt S type manual correct tension device

*Up belt adopt double cylinder S type  tension device,down belt manual  tension device(small amount adjust)

*Drive rollers' surface is wrapped by rubber with middle height,to make sure the board output smoothly

*Main drive motor: Variable frequency motor, high force when low speed start, high speed adjusting range, steady to use,easy to mend

*The electrical components adopt international famous brands,  working stably and reliable

Working Width	2200mm
Steam Pressure	0.8-1.3Mpa
Air Pressure	0.6-0.9Mpa
Up Drive Roller	Φ637mm
Down Drive Roller	Φ637mm
Front Driven Belt Roller	Φ321mm
Back Shaping Driven Belt Roller	Φ215mm
Belt Press Roller	Φ70mm
Shaping Holder Roller	Φ86mm
Note: All the surfaces of the rollers are ground and then chromed plated