How to maintain the Folder Gluer Machine

1. The width of the paper box glue mouth and the rubber wheel shall match. In the process of automatic pasting, the width of the paper box should meet the requirements of the pasting machine, too wide and too narrow will affect the quality of the paste box. If it is too narrow, the glue will overflow; if it is too wide, the pre folding will be affected to a certain extent. In addition, the concentricity of the upper rubber wheel should ensure accurate packaging anti-counterfeiting, and the knurling on the edge should be free of wear, so as to ensure even glue application.
2. Before gluing, make sure that the conveying route of the carton adhesive edge is parallel to the conveying belt.
3. The gap between the upper and lower rubber wheels and the amount of glue applied shall be suitable for food packaging to ensure the thin and even coating layer.
4. The folding part is equipped with folding transmission. If necessary, it is necessary to adjust the folding transmission to ensure the accurate alignment of the adhesive port.
semi-automatic-box-gluing-machine11383652758
5. Do not touch other parts of the machine again when the adhesive has been coated, otherwise the glue will accumulate more and more in this part, and finally rub against the parts that should not be coated.
6. The gluing position should be appropriate, too far away from the crease line, and the box is not beautiful. Too close may cause the position that should not be glued to be glued to be bound, resulting in the box forming difficulty.

上一文章：The daily life of the Folder Gluer Machine factory

下一文章：暂无